« zur Übersicht Produkt 16 / 20
SkyRC - SK600066
Verbrennungsmotoren HeizsystemThe SKYRC engine heater uses technology similar to that used by Formula 1, Indy Car and NASCAR Teams! It will properly pre-heat your engine to 60-70°C in 10 minutes based on ambient temperature.
SKYRC engine heater will pre-heat all the critical parts of your nitro engine, giving you a minimal of stress and wear on the engine. It help relieve the stress on the crank, con-rod, piston and sleeve during warm-up. It also give you a very easy and smooth engine start, with no stress on your starterbox. Fuel consumption is much less, as you do not have to spend time warming up and adjusting your engine. A pre-heatet glow-plug will increase the life of your plug. It is also perfect for break-in, as it reduces the "pinch" on your new engine. You will experience that engine pre-heating is a must. Most importantly, it will quickly pay for itself by increasing engine life and performance!
- Small, Lightweight, Compact
- Easy Operating
- LED indicator: Heating (RED LED) Low Voltage (RED LED Blinking)
- MCU control heating time and heating power for maximum safety.
- Safety timer: turn off power around 10 minutes automatically.
- Built-in temperature sensor: to control the output power of the heater.
- LED indicator for status of engine heater.
- 12V DC source with low voltage cutoff.
- Fireproof and heat resistant adjustable cover.
- Fits all .19-.26 RC nitro engines.
- Very small, lightweight and compact for quick and easy storage.
- It's designed to transfer heat effectively and efficiently.
- Access port on top allows you to start and monitor your engines temperatures without having to take the heater off.
The Set Contains:
- SKYRC ENGINE HEATER
- XT60 DC Wire
- Input Voltage: 12Volt DC
- Heating Power: 90Watt
- Heating Time Around: 10 Minutes
- Low Voltage Cutoff: 9-10Volt
- LED Indicator Heating:
- Red LED Stays On
- Low Voltage Red LED Blinking
- Net Weight: 65g
- Dimension: Diameter: 63mm / Height: 50mm